We make your ideas
  • laser cutting grey board_cutlasercut.jpg, laser cutting grey board

    Laser cut material sample

  • Laser engraved_greyboard_cutlasercut.jpg, Laser engraved greyboard

    Engraved strokes & fonts

  • Laser cut greyboard tolerance tests_cutlasercut.jpg, laser cut greyboard tolerance tests_cutlasercut

    Laser cut test widths

  • Greyboard with burn marks _cutlasercut.jpg, 2.2mm greyboard

    Laser cut sample – 2200 micron grey board

  • Grey boards laser cut with burn marks.JPG, greyboard cut rest widths

    2200 micron grey board cut test widths

  • Laser cut material sample Laser cut material sample
  • Engraved strokes & fonts Engraved strokes & fonts
  • Laser cut test widths Laser cut test widths
  • Laser cut sample - 2200 micron grey board Laser cut sample - 2200 micron grey board
  • 2200 micron grey board cut test widths 2200 micron grey board cut test widths

Grey board (recycled)

Our supply: Stock material
Thickness: Available in 1400 micron and 2200 micron
Sheet sizes: 910×610mm only
Your supply: You can also supply your own card at any thickness and any sheet size up to our maximum bed size of 2400×1200mm.

Download material drawing templates



Adobe illustrator: *.ai drawing templates
Coreldraw: *.cdr drawing templates
AutoCad: *.dxf drawing templates
Inkscape: *.svg drawing templates

See the drawing guidelines for more on setting up a file using the drawing templates.»


?

See more on laser cutting paper and card»
See more on our laser cutting service for architecture and modelmaking»

Material Properties

Made from 100% recycled paper. Grey board consist of glued layers of paper fibres with a smooth surface on both sides. Since it is made from recovered paper and is not bleached, the grey tones will vary slightly from board to board.


Typical applications

Art & sculpture, architectural models, business cards, display and decorative, graphic design, picture framing, prototyping


Appearance

Because greyboard is produced from natural paper fibres and are not bleached, variation in tone can occur from sheet to sheet.


Laser cutting

Protective backing can’t be used on grey board as it rips the material surface.

Top surface

Cutting greyboard can be quite messy on thicker . Lots of dusty residues are produced which will mark the material surface surrounding the cut lines.

Bottom surface

Where possible, we try to float greyboard on the lamella to keep contact with the laser bed to a minimum when cutting. If your artwork is particularly dense, we will need to use honeycomb which will results in surface markings. Heat from the laser causes residues on the honeycomb to transfer back onto the material. We try to keep this to an absolute minimum using a low laser power but unfortunately these reverse markings are unpreventable. (See more image of marking on paper)


Cut widths & Kerf

The average cutting kerf for greyboard is +/- 0.2mm (how much the laser takes away.)
As a benchmark, we recommend that minimum cut widths be no smaller than the corresponding thickness of the material. See more on min cut widths.


Cut edge

Grey board laser cuts with a slightly brown / yellow edge. Dust particles from the laser cut edge rub off very easily so components need to be handled with care.


Raster & Vector engraving

Our standard engraving setting is quite shallow to avoid heat build up and excessive marking on the top surface. Grey board engraves with a brown / yellow appearance and with good clarity.


Deeper engraving

We can engrave deeper into the grey board surface but this can cause more scorch marks and black dust particles around the surrounding engraved area which dirty the material surface.